Opportunities of accelerating the GANS production

From Keshe Foundation Wiki
Revision as of 15:56, 8 January 2019 by Andreas (talk | contribs)$7

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

GANS production with current, resistor, fishtank pump.

When you produce GANSes with current, it takes a little bit longer, but the quality is better.

If you need a GANS quick, you can use current/electricity, also a battery is good for it. Depending on the GANS and electricity, you have too use a fishtankpump too.

Read detailed descriptions:

CO2

If you use for example for a CO2 production a fully charged 1.5V AA battery is to much power and the CO2 gets to dark from it. So instead of it you can use a resistor, which you set in serial (150 Ohm and 15 to 20 mA) (picture besides).

ZnO

To speed up the ZnA production you can use a small amount of DC current and optional also an aerator (fish tank pump). You can also use a DC device that provides approximately 15 mA DC current between the two plates (or coils) instead of the Copper wire. The negative pole of the device is connected with to the Nano-coated Zinc and the positive pole of the device is connected to the uncoated Zinc. If you use a current you can use an aerator (fish tank pump) to provide additional Oxygen to the Salt water solution.

CH3

Unlike the production of CO2 GANS, you can use a very small amount of DC current and a fish tank pump (aerator) to speed the production process, but the pump is not mandatory. At first, there will be a reaction between Zinc and Nano-coated Copper, after a while, the reaction between Iron and nanocoated copper starts. You can use a common, adjustable DC device, which produces current of approximately 15 mA between the two metal plates instead of the connection of a Copper wire. If you do, the negative pole of the device is attached to the Nano-coated Copper coil or plate and the positive pole of the device is connected to the iron. You could also use a 1.5 V battery as power source. If you use any kind of current you should aerate the Salt solution with a small fish tank pump. It will only take a few hours to produce a reddish brown layer of CH3 GANS at the bottom of the container. To get a better result, you can mount a coil of a PC fan between the two plates instead of a wire or a current source.

CuO

To speed up the GANS production process, you can use a small amount of DC current and a small aerator (fish tank pump). A DC-device, which provides approximately 15 mA DC current between the two plates, or coils, can be used instead of the Copper wire between the plates. The negative pole of the device is connected to the Nano-coated Copper and the positive pole of the device is connected to the uncoated Copper. If you use a current you must apply an aerator to provide additional Oxygen to the Salt water solution. After a few hours a turquoise layer builds on the bottom of the container and settles there. This is CuO GANS. To get a better result, you can mount a coil of a PC fan between the two metals instead of a wire or a current source.