How to make Plasma-water and dried GANS
| Basics for the production and processing of GANS | |||
| back to categorie: GANS | |||
How to make Plasma Water
After the last time the Salt water was removed to wash out the GANS, a part of the Amino Acid is added to the GANS and mixed with the GANS.
Clean water is poured into the container again, the container is shaken and the GANS mixes with the water. It depends on the GANS, how fast it settles down on the ground again. It is recommended to wait 24 hours. This gives the GANS time to settle and transfer its magnetic and gravitational field strength into the water, depending on the field strength of the GANS that was created.
The water sitting above the GANS in the container has been plasmatized and is now Plasma Water. It can be used for various applications.
When you remove Plasma Water from the GANS storage container for application purposes, ensure that you take ONLY the clear water from the container. DO NOT take GANS from the container, unless you need it for a specific application.
Every time you remove clear Plasma water from the container, pour water into the container to refill it, seal it and let it stand for at least 24 hours before using the Plasma water for application purposes.
The GANS continues to transfer its field strength to the clean water.
How To Dry GANS
GANS can be used in a moist or solid state. You can store GANS in clean water, keeping it moist, or you can remove it from the water and dry it into a solid powder. In the end, the properties of the GANS remains intact in either state. For health application we most often use GANS water.
Sometimes dried GANS is preferable for a particular application. When drying GANS the aim is to do it naturally to gently withdraw moisture from the GANS. Under no circumstances is GANS to be dried by heating it over an open fire or on a stove top. The more natural the drying process, the better. It is possible to speed the drying process by putting the moist GANS on top of a heating radiator or heating vent, or by placing the GANS near a lamp that has a heat producing bulb. If crystals form during the drying process, this is an indication that the GANS was not washed thoroughly during the GANS washing process. The crystals are likely salt crystals. During the drying process the GANS will turn to a paste, and after more hours pass it will turn to a powder.
CuO GANS powder.
CuO GANS paste and CH3 GANS powder.
CH3 GANS that has not been throughly washed showing the formation of Salt crystals during the drying process.
Drying of the GANS on top of the heating
